Ingenico iSC250 - Mac Address

What do I need to set-up the isc250?

  • Ingenico iSC250
  • iSC250 power supply
  • iSC250 Ethernet cable
  • TranCloud Unit
  • TranCloud power supply

1.)  Connect iSC250 Ethernet cable to the back of the Ingenico iSC250 and into one of the LAN ports on your internet router.

Connecting the Ethernet cable
Note:  The make/model of your internet router and the Ethernet cables connected to it will look different than the one used to make this guide.

Note:  The make/model of your internet router and the Ethernet cables connected to it will look different than the one used to make this guide.

2.)  Connect iSC250 power supply to 120V power outlet and to the back of the iSC250 Ethernet cable.

Power Cable
 
Note: iSC250 will turn on once it's connected to power.

3.)  Once the iSC250 loads the "splash" screen, quickly press 2-6-3-4, enter key, followed by the "+" key.

iSC250 splash screen

iSC250 splash screen

iSC250 Buttons

4.)  Use the included stylus to scroll down and select "TDA".  

TDA
 

5.)  For the remaining steps, you'll need to use the +/- keys to scroll up and down. Select "Configuration" and press the enter key, "Communication" and press the enter key, and "Select Comm. Type" and press the enter key.  Choose "Ethernet" and press the green enter key.  Press the red cancel key to return to the previous screen.

Plus/Minus Keys
Configuration
Select Comm Type
Communication
Ethernet

6.)  Scroll down to "Ethernet settings" and press the enter key.  Scroll down to "DHCP". press the enter key.  Select "Auto". Press the enter key. Be sure to press the enter key after changing any settings.  

Ethernet Settings

Ethernet Settings

DHCP

DHCP

DHCP TYPE: Auto

DHCP TYPE: Auto

Scroll through the "Ethernet settings" options to confirm the following settings:

  • "Connection Method" is set to "Server"
  • "IP Port" is set to "12000"
  • "-SSL" is set to "No" 

7.)  Press the red cancel key three times.  Press the "1" key (Yes) at the "Save and Reboot" screen. The iSC250 will then reboot.

The iSC250 will reboot with the settings for Ethernet connection after you select "yes"
 

8.)  Connect TranCloud unit to 120V power outlet using included TranCloud power supply.  

Note:  After powering TranCloud unit, allow the Tran one minute to scan for MAC Address.