Ingenico iPP350 - Mac Address
What do I need to set-up the iPP350?
- Ingenico iPP350
- iPP350 power supply
- iPP350 Ethernet cable
- TranCloud Unit
- TranCloud power supply
1.) Connect iPP350 Ethernet cable to the back of the Ingenico iPP350 and into one of the LAN ports on your internet router. CONNECT IPP320 POWER SUPPLY TO 120V POWER OUTLET AND TO THE BACK OF THE IPP350 ETHERNET CABLE.
Note: iPP350 will turn on once it's connected to power.
2.) Once the iPP350 loads the "splash" screen, quickly press 2-6-3-4, green enter key, followed by the "F" key.
3.) Use the "F2/F3" keys to scroll down and select "TDA". Press the green enter key.
4.) For the remaining steps, you'll need to use the "F2/F3" keys to scroll up and down and the green enter key to confirm selections and make changes. Select
"Configuration" and press the enter key, "Communication" and press the enter key, and "Select Comm. Type" and press the enter key. Choose "Ethernet" and press the green enter key.
5.) Scroll down to "Ethernet settings" and press the enter key. Scroll down to "IP Address" and press the enter key to enter your wireless network's IP Address. Press enter followed. Select "Gateway" and press the enter key to enter your Gateway Address. Be sure to press the enter key after changing any settings.
Scroll through the "Ethernet settings" options to confirm the following settings:
- "Connection Method" is set to "Server"
- "IP Port" is set to "12000"
- "-SSL" is set to "No"
6.) Press the red cancel key three times. Press the "1" key (Yes) at the "Save and Reboot" screen. The iPP350 will then reboot.
7.) Connect TranCloud unit to 120V power outlet using included TranCloud power supply.
Note: After powering TranCloud unit, allow the Tran one minute to scan for MAC Address.